Dell powerconnect 6248 reset to factory default

DELL POWERCONNECT 6248 RESET TO FACTORY DEFAULT HOW TO

To open the Restore Defaults page, click System >File Management >Restore Defaults in the tree view. The Restore Defaults page allows you to restore the device settings to their factory default values. NOTICE: By default, the IP address is assigned to VLAN 1 through DHCP. how do i set dell 2848 switch to default. Anything outside this format is not accepted by the CLI program.

Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods. You can statically configure a specific IP address or direct the switch to obtain an address from a Boot Protocol (BOOTP) or Dynamic Host Configuration Protocol (DHCP) server when it is powered on. You may also need to a establish a default gateway between the switch and management stations that exist on another network segment. 'You must assign an IP address to the switch to gain management access over the network. So my question is - what temps do these normally run at and is there a thermal shutdown if they exceed their safe operating temps? Obviously I'd prefer to avoid running the original fans as they're noisy (the 120mm is near silent yet still shifts a large amount of air) but equally I'd rather not come home to a smouldering charred house because the switch has caught fire. However in use (i.e when I've connected up several PC's and NAS') its getting hotter on the underside. So I drilled a multitude of holes in the top cover above some of the hotter components (PSU and a couple of cooling fins in front) and added a large 120mm fan externally to the top cover above the ventilation holes, this seemed to have brought temps right down on idle (yes I took the top cover off before drilling the vent holes!!). I've disconnected the 3 fans to try and run it passively but it got pretty damn hot. I wanted to use it in my home network and using it with the std 3 40mm screamer fans is just too noisy. NOTHING.Д¬urrently, the trunk card for xg1/2 is removed from both switches.I've managed to pick up cheaply a Dell Powerconnect 5224 24 Port Gigabit switch. I CANNOT FIND ANYTHING WHATSOEVER! I have tried holding it down for 20 seconds on power on as well as doing the same with power already on. I can successfully upload backed-up configs to a switch, if the switch is set to factory defaults, with the original IP address re-configured.

DELL POWERCONNECT 6248 RESET TO FACTORY DEFAULT HOW TO

I have searched high and low for documentation on how to use the front panel reset button to reset the switch. Dell PowerConnect 6248 3NKR9T1show system System Description: Dell Ethernet Switch System Up Time: 0 days, 00h:49m:34s System Contact: System Name: 3NKR9T1 System Location: Burned In MAC Address: 810 System Object ID: 1.3.6.1.4.1.674.10895.3011 System Model ID: PCT6248 Machine Type.

The Power and Fan lights flicker after power cycling like there is activity but nothing on console and no lights on any ports if I plug in. I have tried everything I know to do but cannot get ANY console activity. NOW member 2 is exhibiting the exact symptoms.

Through a combination of power cycling and removing trunk cables I have been able to get member 1 responsive and reset to factory default. I replaced both switches and now trying to get these working again. Member 1 has Master light on as well as Power and Fan but no port lights at all. member 2 took on role of master and booted fine. A power loss rendered member 1 (master) unresponsive.

Dell powerconnect 6248 reset to factory default